Powerplus POW306502 DRILL/SCREWDRIVER 14.4V 2BATT EN - Manual (Page 8)

POW3065.. EN
Copyright © 2012 VARO P a g e | 8 www.varo.com
9 CLEANING AND MAINTENANCE
9.1 Cleaning
§ Keep the ventilation slots of the machine clean to prevent overheating of the engine.
§ Regularly clean the machine housing with a soft cloth, preferably after each use.
§ Keep the ventilation slots free from dust and dirt.
§ If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10 TECHNICAL DATA
POW30650
POW30650/2 POW306532 POW306552
Voltage / frequency charging unit 230 V / 50 Hz
Rated Voltage 14.4 V 18 V 18 V
Rotation speed 1
st
gear 0-350 rpm
Rotation speed 2
nd
gear 0-1250 rpm
Torque positions 24
Max. drill capacity 10 mm
Charger time 3/5 hours 1 hour
Battery capacity 1300 mAh
Battery type Ni-CD
Max. torque 15 Nm
Drill capacity concrete /
Drill capacity steel 10 mm
Drill capacity wood 20 mm
Chuck type Sanou keyless chuck
Number of speed settings 2
11 SOUND EMISSION
Noise emission values measured according to relevant standard.
Acoustic pressure level LpA 74dB (A) K = 3 dB(A)
Acoustic power level LwA 85 dB (A) K = 3 dB(A)
ATTENTION! The sound power pressure may exceed 85 dB(A), in this case
individual hearing protection must be worn.
aw (Vibration) 6.5 m/s² K = 1.5 m/s²
12 SERVICE DEPARTMENT
§ Damaged switches must be replaced by our after-sales service department.
§ If the connecting cable (or mains plug) is damaged, it must be replaced by a particular
connecting cable which is available from our service department. Replacement of the
connecting cable must only be carried out by our service department (see last page) or by
a qualified person (qualified electrician).