Powerplus POW60481 GRASS TRIMMER 30CC 420MM EN - Manual (Page 6)

POW60481
EN
Copyright © 2014 VARO P a g e | 6 www.varo.com
 DO NOT operate unit for prolonged period. Rest periodically.
 DO NOT OPERATE UNIT WHILE UNDER THE INFLUENCE OF ALCOHOL OR DRUGS.
 DO NOT OPERATE UNIT UNLESS DEBRIS SHIELD AND/OR GUARD IS INSTALLED
AND IN GOOD CONDITION
 DO NOT ADD, REMOVE OR ALTER ANY COMPONENTS OF THIS PRODUCT. Doing
so could cause personal injury and/or damage the unit.
 DO NOT operate your unit near or around flammable liquids or gases whether in or out of
doors. An explosion and/or fire may result.
5.3 Danger of fire and burn injuries.
 Always use extreme care when handling fuel! Fuel is highly flammable.
 Never attempt to fuel the line trimmer if the fuel system components are damaged or are
leaking.
 Never attempt the refuel the engine while it is running or still warm, allow it to cool before
fuelling.
 Never smoke or light any fires near the line trimmer or fuels.
 Always transport and store fuels in an approved container.
 Never place flammable material close the engine muffler.
 Never operate the line trimmer without a properly functioning muffler and spark arrestor
installed.
 Never operate the line trimmer unless it is properly assembled and in good working
condition.
 Do not use petrol which contains ethanol or methanol as it may damage the fuel lines and
other engine parts.
 Mix only enough fuel for your immediate needs. If fuel must be stored longer than 30 days,
it should first be treated with a stabilizer or similar product.
5.4 Observance while operating
 Operate alone without assistance. Do not allow anyone to enter within a 15- meter radius
from the operator.
 If several grass trimmers are in use simultaneously, keep minimum 15 meter distance
from each operator.
 Avoid stones and stumps. This may damage the cutting line. Should you hit something
accidentally, stop engine and check the cutting line for damage.
 An operator must have a firm footing when using a grass t. Do not operate during rain.
 Be sure that a cutting head is attached firmly in an adequate position.
 Do not cut tri close to an edge of a fence, a cliff or such hard objects.
 When removing foreign objects wound around a cutting head, a gear case or a guard, be
sure to stop an engine by an ignition switch. While an engine is running, never put your
hands etc. close to a cutting line even if it is not rotating. Your motion may let a throttle
cable pulled to suddenly raise an engine revolution, which may get you hurt by a rotating
cutting line.