Powerplus POW60481 GRASS TRIMMER 30CC 420MM EN - Manual (Page 7)

POW60481
EN
Copyright © 2014 VARO P a g e | 7 www.varo.com
6 ASSEMBLY
It is necessary to fit the drive shaft the handle safety guard, harness and adjust the handle and
harness.
6.1 Fitting the plastic guard
Slide the plastic guard over the drive shaft as shown in the
picture.
Place plastic guard over drive shaft until metal piece fits in the
guard and you can fit the bolt through the guard and metal
piece. Tighten the bolt.
6.2 Fitting the curvy drive shaft
Put lower part into the shaft of the upper part. Push down the
iron bullet and push forward until the bullet fits into the
restrictor hole. Tighten the screw bolt manually.
6.3 Fitting the handle
6.3.1 If you use the "OPEN" type handle bar, by the following method:
Loosen the handle bar by unscrewing the bolt. Slide the O-shaped handle bar over the drive
shaft. Leave 135 mm between the O-shaped handle and the operating handle. Tighten the
bolt to fix the O-shaped handle.
WARNING! Do not use the line cutting head without the plastic guard.