Powerplus POW6103 HEDGE TRIMMER 500W 466MM EN - Manual (Page 6)

POW6103 EN
Copyright © 2015 VARO P a g e | 6 www.varo.com
7.3 Power Cord
 To prevent the power cord from disconnecting from the hedge trimmer, loop the cord
around the recessed hook and pull gently to tighten.
8 CLEANING AND MAINTENANCE
Warning! Before performing any work on the equipment, pull the power
plug.
 Check your machine regularly before starting the work.
 Damaged cutting blades have to be repaired or exchanged by a qualified service man
before working with the machine
 After each cutting operation, clean the cutting blade with a soft brush and cloth with
lubricating fluid oil and spray a thin layer of fluid protective oil on the completes blade.
 Always keep the ventilation slots in motor housing clean
 Never clean or spray a machine with water .clean the motor housing only with a moist
cloth and never apply detergents or solvents! These could ruin the plastic parts of the
machine ,Finally, dry the motor housing carefully.
 Only use original accessories and spare parts.
9 TECHNICAL DATA
Type POW6103
Voltage / frequency 230-240V~ 50Hz
Power input 500W
Blade length 466 mm
Cutting length 410 mm
Cutting capacity 18 mm
No load speed 1600 min-1
10 NOISE
Noise values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
82 dB(A)
Acoustic power level LwA 96 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration) 3,4 m/s² K = 1,5 m/s²
11 SERVICE DEPARTMENT
 Damaged switches must be replaced by our after-sales service department.
 If the connecting cable (or mains plug) is damaged, it must be replaced by a particular
connecting cable which is available from our service department. Replacement of the
connecting cable must only be carried out by our service department (see last page) or by
a qualified person (qualified electrician).