Powerplus POWX067 ANGLE GRINDER 2450W 230MM EN - Manual (Page 11)

POWX067
EN
Copyright © 2010 VARO p a g e | 11 www.varo.com
9.2 Flange arrangement when using a depressed-centre cutting wheel
9.3 Flange arrangement when using a straight cutting wheel
10 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
10.1 Cleaning
§ Keep the ventilation slots of the machine clean to prevent overheating of the engine.
§ Regularly clean the machine housing with a soft cloth, preferably after each use.
§ Keep the ventilation slots free from dust and dirt.
§ If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10.2 Lubrication
The machine does not require any specific lubrication.
10.3 Replacing Coal Brushes
Remove and check the carbon brushes regularly. Replace when they have worn down to the
limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon
brushes must be replaced at the same time. Only use original carbon brushes.