Powerplus POWX067 ANGLE GRINDER 2450W 230MM EN - Manual (Page 7)

POWX067
EN
Copyright © 2010 VARO p a g e | 7 www.varo.com
7 OPERATION
7.1 Fitting the auxiliary handle
Ensure that the plug is not in the socket when fitting or removing the
auxiliary handle.
Fig. 1
The auxiliary handle (8) can be attached to the angle grinder in three different positions: left,
on top and right.
7.2 Assembly the protective guard
Fig. 2 Fig. 3
1. Loosen the clip of the protective guard (9) by pulling lock lever of protective guard (1)
outward.
2. Turn the protective guard so that uncovered part of the disc is as far apart as possible from
the hand on main handle (4).
3. Fix the protection guard by pushing the lock lever
inwards (the protective guard should no
longer be able to move).
NOTE: If the protective guard can not be fixed firmly by the lock lever (1), use a hexagon
wrench to tighten the hexagon nut. (See attached figure 4)