Powerplus POWX102 HEAT GUN 1800W EN - Manual (Page 6)

POWX102
EN
Copyright © 2014 VARO NV P a g e | 6 www.varo.com
Make sure that the tool is switched off and the nozzle has cooled down.
Set the desired accessory onto the nozzle.
8 INSTRUCTIONS FOR USE
Always observe the safety instructions and applicable regulations.
 Use only one hand to hold the tool Do not place your other hand over the air vents
Prior to operation:
 Mount the correct accessory for the application.
 Set the desired air temperature.
8.1 Switching on and off
 To switch the tool on, set the on/off switch to position LOW/HIGH. Some smoke may be
emitted after switching on; this does not indicate a problem.
 To switch the tool off, set the on/off switch to position OFF. Let the tool cool down before
moving or storing it.
8.2 Temperature setting.
Turn ON/OFF switch to LOW or HIGH, depending on temperature you need.. The heat gun
will start to buzz and the present temperature of the air outlet will be shown on LCD display (3).
Now you can increase or decrease the outlet temperature gradually by turning the adjust knob
(5). Turn anti-clock wise to decrease, clock wise to increase the temperature. The
temperature on the display will gradually follow your setting
8.3 Stripping paint
 Mount an appropriate accessory.
 Set a high air temperature.
 Switch the tool on.
 Direct the hot air onto the paint to be removed.
 When the paint softens, scrape the paint away using a hand scraper.
Do not strip metal window frames, as the heat may be conducted onto the
glass and crack it. When stripping other window frames, use the glass
protection nozzle.
Do not keep the tool directed at one spot too long to prevent igniting the
surface.
Avoid collecting paint on the scraper accessory, as it may ignite. If
necessary, carefully remove paint debris from the scraper accessory using a
knife.