Powerplus POWX102 HEAT GUN 1800W EN - Manual (Page 7)

POWX102
EN
Copyright © 2014 VARO NV P a g e | 7 www.varo.com
8.4 Stationary use
This tool can also be used in stationary mode.
 Place the tool onto the workbench.
 Secure the cable to prevent pulling the tool off the workbench.
 Carefully switch the tool on.
Make sure that the nozzle always points away from you and any
bystanders.
Make sure not to drop anything into the nozzle.
8.5 Cooling down
The nozzle and accessory become very hot during use. Let them cool down before attempting
to move or store the tool.
 To reduce the cooling time, switch the tool on at the lowest air temperature setting and let
in run for a few minutes.
 Switch the tool off and let it cool down for at least 30 minutes.
9 MAINTENANCE AND CLEANING
Attention !Before performing any work on the equipment, pull the power
plug.
9.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
9.2 Lubrication
Your power tool requires no additional lubrication
10 TECHNICAL DATA
Voltage 230 V – 50 Hz
Power input 1800 W
Air temperature / air
stream
Low 75°-400° /* 250 l/min
High 85°-600° /* 550 l/min