Powerplus POWXG2040 TELESCOPIC HEDGE TRIMMER 800W 480MM EN - Manual (Page 6)

POWXG2040
EN
Copyright © 2013 VARO P a g e | 6 www.varo.com
7.3 Adjust the cutting angle
 Press the rotating knob.
 Adjusting the cutting head to a comfortable position.
 Release the knob.
7.4 Starting and stopping the machine
 To start the tool: press the safety button (11) and then press the trigger (12). Release the
safety button once the motor has started.
 To stop the trimmer: Release the trigger.
Do not connect to power supply until assembly is complete, Failure to
comply could result in accidental starting and possible serious personal
injury.
8 CUTTING TIPS
 Assume a secure position, using two hands to hold the trimmer and switch on.
 Trim both sides of the hedge, starting at the bottom. This prevents cuttings falling into the
area yet to be cut.
 Pass the blade lightly through the surface of the hedge. Do not attempt to cut too deep.
 Trim the top of the hedge.
 For older hedges that require cutting back substantially, use pruning shears to cut the
thicker branches and then finish the job with the hedge trimmer.
 Never use the hedge trimmer without check the tightness of the bracket.
9 CLEANING AND MAINTENANCE
Warning! Before performing any work on the equipment, pull the power
plug.
 Check your machine regularly before starting the work.
 Damaged cutting blades have to be repaired or exchanged by a qualified service man
before working with the machine
 After each cutting operation, clean the cutting blade with a soft brush and cloth with
lubricating fluid oil and spray a thin layer of fluid protective oil on the completes blade.
 Always keep the ventilation slots in motor housing clean
 Never clean or spray a machine with water .clean the motor housing only with a moist
cloth and never apply detergents or solvents! These could ruin the plastic parts of the
machine ,Finally, dry the motor housing carefully.
 Store the machine with the supplied protection cover(15)
 Only use original accessories and spare parts.