Powerplus POWXG2040 TELESCOPIC HEDGE TRIMMER 800W 480MM EN - Manual (Page 7)

POWXG2040
EN
Copyright © 2013 VARO P a g e | 7 www.varo.com
10 TECHNICAL DATA
Type POWXG2040
Voltage ~Frequency 230V~50Hz
Power input 800 W
Blade length 480 mm
Cutting length 360 mm
Cutting capacity 24 mm
No load speed 1500 /min
Telescopic length 1,5m tot 2,5m
Weight 5,6 kg
11 SOUND EMISSION
Noise emission values measured according to relevant standard.
Acoustic pressure level LpA
89dB (A) K = 3 dB(A)
Acoustic power level LwA 103dB (A) K = 3 dB(A)
ATTENTION ! The sound power pressure may exceed 85 dB(A), in this case
individual hearing protection must be worn.
aw (Vibration) 2,5 m/s
2
K = 1,5 m/s²
12 TROUBLESHOOTING
PROBLEM CAUSE ACTION
The hedge trimmer
runs slowly and
remains slightly
jammed
Too low voltage
The extension cable core wire
not dimensioned sufficiently
On the starter being
pushed but the
motor will not start
 The switch fuse was not
pushed in to release the
starter
 The extension cable coupling
released
 Automatic fuse or switch open
 An electric circuit on the unit
opens
 Push the starter fuse before
pushing the starter
 Check cable coupling
 Check automatic fuse or
switch
 Call authorised servicing
centre
The motor runs but
the blade not.
Jammed in the gear box. Call authorised servicing center.
The unit is smoking The unit is faulty. Do not use it Call authorised servicing centre
The blade is so hard
to cut the branches
or find it’s smoking.
No lubrication on the blade.
After each use, clean the blades
and lightly lubricate with general
purpose oil or spray lubricant.