Powerplus POWXG2032 GRASS/HEDGE SHEAR 7.2V LI-ION EN - Manual (Page 9)

POWXG2032 EN
Copyright © 2014 VARO S i d e | 9 www.varo.com
8 WORKING INSTRUCTIONS
Keep your fingers away from the blades.
8.1 Shrub shear
8.1.1 Cutting hedges
Before cutting check the hedge for foreign objects e. g. wire fences.
Cut stems up to 8 mm in thickness. When cutting, move steadily along the line of cut, so that
stems are fed directly into the cutter blades. The double edge of the cutting blade enables
cutting to either direction, or with a side to side motion.
After use replace the blade transport guard.
Recommended cutting/trimming times:

Cut hedges with deciduous leaves in June and October.

Cut evergreen hedges in April and August.

Cut conifer and other fast growing shrubs approx. every six weeks from May onwards.
8.2 Grass shear
8.2.1 Edging
Guide the machine along the edge of the lawn. Do not allow the blade to contact paved
surfaces, stones or garden walls, since this will wear the blade rapidly.
9 MAINTENANCE
Note: To ensure long and reliable service, carry out the following
maintenance regularly.
 Check for obvious defects such as loose, dislodged or damaged blade, loose fixings and
worn or damaged components.
 Check that covers and guards are undamaged and correctly fitted. Carry out necessary
maintenance or repairs before using.
 If the machine should happen to fail despite the care taken in manufacturing and testing,
repair should be carried out by our technical department.