Powerplus POWXG3005 GRASS TRIMMER 550W 330MM EN - Manual (Page 6)

POWXG3005
EN
Copyright © 2014 VARO P a g e | 6 www.varo.com
7 ASSEMBLY
The trimmer is supplied with some components which need to be assembled. Please
proceed as follows:
7.1 Safety guard assembly
 Insert the safety guard (11) onto the motor
housing and secure it with 4 screws.
 Carfully peel off the tape overt he cutting
blade (14)
Warning: the guard has a very sharp cutting edge on 1 side for cutting the
nylon line.
7.2 Wheel assembly
 Adjust the location of the safety guard and the wheel
assembly.
 Be sure that the pillar of the safety guard can insert
the hole of the wheel assembly.
 Then fix them firmly with 2 screws by the driver.
7.3 Auxiliary handle assembly
 Adjust the location of the auxiliary handle and the locking base.
 Insert the locking knob and lock them firmly in a clockwise direction.
 If you want to adjust the angle of the auxiliary handle, loosen the locking knob counter
clockwise, rotate the auxiliary handle as you want. When it reach a proper location, lock
the locking knob firmly in a clockwise direction again.
8 OPERATION
8.1 Starting
 To switch on the trimmer first press the On/Off trigger (5). To switch off simply release the
On/Off switch trigger(5)
 If you find that the nylon line is too short, let the trimmer run for a few seconds without
touching the working area to allow the trimmer to cut the line after it lengthens.
 Do not overload the trimmer, cut in small sections which will greatly improve efficiency by
keeping the trimmer running at high speed,