Powerplus POWXG3010LI GRASS TRIMMER 18V LI-ION 230MM EN - Manual (Page 9)

POWXG3010LI
EN
Copyright © 2013 VARO P a g e | 9 www.varo.com
10.6 Battery autonomy
Light conditions : Medium conditions : Tough conditions :
up to 800 metres up to 350 metres up to 60 metres
11 CLEANING AND MAINTENANCE
Attention ! Before performing any work on the equipment, remove the
battery from the machine.
11.1 Cleaning

Keep the ventilation slots of the machine clean to prevent overheating of the engine.

Regularly clean the machine housing with a soft cloth, preferably after each use.

If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
11.2 Maintenance
Note: To ensure long and reliable service, carry out the following maintenance regularly.

Regularly check for obvious defects such as loose fixings, and worn or damaged
components.

Check that covers and guards are undamaged and correctly fitted.

Carry out necessary maintenance or repairs before using.
11.3 Blade Maintenance
Attention ! Before performing any work on the equipment, remove the
battery from the machine.

To remove the worn blade(8), push it in direction of the arrow until it snaps off the
pivot(19). (Fig. C)

Clean the pivot of any residual plastic/debris with a sharp knife.

To refit the new blade, place the eyelet over the pivot and pull outwards until it snaps into
place.
Note: Only use original POW XG3011CB as replacement blades. They have been developed
specially for improved cutting.