Powerplus POWXG6026 LAWN MOWER 190CC 502MM EN - Manual (Page 10)

POWXG6026 EN
Copyright © 2014 VARO P a g e | 10 www.varo.com
11.2 Changing /draining the oil.
The oil drain plug is located under the dipstick, at the base of the engine.
Have a container ready to catch the oil.
Remove the drain plug.
Once the oil has been emptied, replace the drain plug.
Make sure that the washer is in place !
To fill proceed as described under 11.1 oil (fill/check).
Start the engine and allow it to run briefly. Stop the engine, wait one minute and check the oil
level. Top up if necessary.
11.3 Draining the fuel tank / carburettor
 Place an approved gasoline container below the carburettor, and use a funnel to avoid
spilling fuel.
 Remove the drain bolt, then move the fuel valve lever to the ON position.
 After all the fuel has drained into the container, reinstall the drain bolt and washer.
 Tighten the drain bolt securely.
11.4 Replacing and cleaning the spark plug
(Only use F6RTC (Nanjing Huade NHSPLD) with engine DY1P64F)
 After the engine has cooled down, remove the spark plug with the provided socket
wrench.
 Clean the spark plug with a wire brush.
 Use a setting gauge (adjustment gauge), and adjust the electrode gap to 0.75 mm.
 Insert the spark plug carefully by hand, in order to avoid any wrong installation (not
properly aligned to thread).
 After the spark plug has been tightened manually, use a wrench to tighten the spark plug
tightly to its washer.
11.5 Lubrication instructions
Caution: disconnect spark plug before servicing.
 WHEELS-Lubricate the ball bearings in each wheel at least once a season with a light oil.
 BLADE CONTROL - Lubricate the pivot points on the start/stop handle of the engine and
the brake cable at least once per season with a light oil. The start/stop handle of the
engine must freely move in both directions.