Troubleshooting, Powxg6026, 13 troubleshooting – Powerplus POWXG6026 LAWN MOWER 190CC 502MM EN User Manual

Page 13

Advertising
background image

POWXG6026

EN

Copyright © 2014 VARO

P a g e

| 13

www.varo.com

13 TROUBLESHOOTING

Problem

Probable cause

Corrective action

Engine does not
start

Fuel tank is empty.

Fill tank with fuel

Air cleaner element is
dirty.

Clean air cleaner element

Spark plug loose.

Tighten spark plug to 25-30 Nm.

Spark plug wire loose or
disconnected from plug.

Install spark plug wire on spark plug.

Spark plug gap is
incorrect.

Set gap between electrodes at 0.7 to
0.8mm

Spark plug is defective

Install new, correctly gapped plug

Carburettor is flooded with
fuel

Remove air cleaner element and pull
starter rope continuously until carburettor
clears itself and install air cleaner element.

Faulty ignition module

Contact the service agent.

Engine difficult
to start or loses
power.

Dirt, water, or stale fuel
tank.

Drain fuel and clean tank. Fill tank with
clean, fresh fuel

Vent hole in fuel tank cap
is plugged.

Clean or replace fuel tank cap.

Air cleaner element is
dirty.

Clean air cleaner element.

Engine
operates
erratically.

Spark plug is defective.

Install new, correctly gapped plug

Spark plug gap is
incorrect.

Set gap between electrodes at 0.7 to
0.8mm

Air cleaner element is
dirty.

Clean air cleaner element

Engine idles
poorly.

Air cleaner element is
dirty.

Clean air cleaner element

Air slots in engine shroud
are blocked.

Remove debris from shots.

Cooling fins and air
passages under engine
blower housing are
blocked.

Remove debris from cooling fins and air
passages.

Engine idles
poorly.

Gap between electrodes of
spark plug is too close.

Set gap between electrodes at 0.7 to
0.8mm

Engine
overheats

Cooling air flow is
restricted.

Remover any debris from slots in shroud,
blower housing, air passages

Incorrect spark plug.

Install FGRTC spark plug and cooling fins
on engine

Mower vibrates
abnormally

Cutting assembly is loose.

Tighten blade

Cutting assembly is
unbalanced

Balance blade.

Advertising
This manual is related to the following products: