Powerplus POWXG9020 HIGH PRESSURE CLEANER 1500W EN - Manual (Page 11)

POWXG9020
EN
Copyright © 2014 VARO P a g e | 11 www.varo.com
13 TROUBLE SHOOTING
SYMPTOM CAUSE RECOMMENDED ACTION
Machine refuses to
start Machine not
plugged in Plug in machine.
Defective socket Try another socket.
Defective extension
cable Try without the extension cable.
Fluctuating pressure Pump is sucking air Check that hoses and connections are
airtight.
Valves dirty, worn
out or stuck Contact your nearest service centre
Water supply not
sufficient Increase water pressure, check for blockage
of garden hose and/or change to bigger hose.
Pump seals worn Contact your nearest service centre
Machine stops Incorrect mains
voltage Check that the mains voltage corresponds to
specification on the name plate
Thermal sensor
activated Leave the machine for 5 minutes to cool down
Nozzle partially
blocked Clean the nozzle with a needle and by
spraying water backwards through the nozzle
Amperage increase Try without the extension cable.
Machine pulsating Air in inlet
hose/pump Allow machine to run with open trigger until
regular working pressure resumes.
Inadequate supply
of mains water Increase water pressure, check for blockage
of garden hose and/or change to bigger hose.
Nozzle partially
blocked Clean the nozzle with a needle and by
spraying water backwards through the nozzle
Water filter blocked Clean the filter
Hose kinked Straighten out hose.
Machine often starts
and stops by itself Pump and/or trigger
gun is leaking Contact your nearest service centre
No water supply Connect inlet water.
Machine starts but no
water comes out Water filter blocked Clean the filter
Nozzle blocked Clean the nozzle with a needle and by
spraying water backwards through the nozzle