Epson Endeavor 468C - Manual (Page 140)

Power-on diagnostics error messages (continued)
Error message Action
FLOPPY DISK The system was unable to detect a diskette drive
CONTROLLER ERROR controller.
OR NO
CONTROLLER
If you have no diskette drive, run SETUP and select
PRESENT
none
for both diskette drives.
If you have at least one diskette drive. see
“Diskette Drive Problems.”
FLOPPY DISK TYPE IS The installed diskette drive does not match the
SET INCORRECTLY CMOS definition. See “Diskette Drive Problems.”
OR DRIVE ERROR
HARD DRIVE The system was unable to detect the hard disk
CONTROLLER drive controller. See “Hard Disk Problems.”
DIAGNOSTICS ERROR
HARD DRIVE SECTOR Your hard disk drive may be damaged. Contact
VERIFY ERROR the Epson Connection.
KEYBOARD ERROR Your keyboard may not be connected correctly.
OR NO KEYBOARD See “Keyboard Problems.”
PRESENT
MEMORY ERROR
DURING MEMORY
TEST
Your SlMMs may not be installed correctly. See
‘Memory Module Problems.”
NON-SYSTEM DISK
OR DISK ERROR The system cannot boot from the diskette. Make
sure the diskette is bootable and see
“Diskette Problems.”
PASSWORD CHECK
FAILED - SYSTEM
HALTED
You’ve entered an incorrect password. See
“Password Problems.”
UNABLE TO INITIALIZE Your hard disk drive cannot be initialized. See
HARD DRIVE (DRIVE “Hard Disk Problems.”
TYPE?)
6-4 Troubleshooting