Epson Endeavor 468C - Manual (Page 73)

How to Use This Chapter
This chapter explains how to do the following:
q Remove and replace the computer’s cover
q Change jumper settings and DIP switch settings on the
main system board
q Install and remove memory modules (SIMMs)
q Install and remove an option card
q Remove and replace the option card connector board
q Install a new processor chip
q Increase the video memory
q Use the VGA feature connector
q Replace the system battery.
Follow the steps in the first section to remove the cover, and
then go to the appropriate section for the instructions you need.
When you finish, see the instructions at the end of this chapter
to replace the computer’s cover.
Note
Your system also supports up to 256KB of extended cache
memory; however, the system board must be removed from
the computer to install the cache memory chips. If you want
to add cache memory, contact your Authorized Epson
Servicer or call the Epson Connection for a referral. Do not
attempt to install cache chips yourself.
4-2 Installing and Removing Options