Edimax Technology AR-6024 - Manual (Page 25)

Per VC Settings
Virtual Circuit: Selection Enable or Disable.
VPI: If instructed to change this, type in the VPI value for the initial connection (using
PVC 0). Default = 0.
VCI: If instructed to change this, type in the VCI value for the initial connection (using
PVC 0). Default = 0
MAC Spoofing: MAC Spoofing is developed to solve the scenario when the ISP only
recognizes one MAC address. Copy the ISP-recognized MAC address here.
ATM
Service Category: UBR and CBR are supported from the ATM.
Bandwidth: Bandwidth setting takes effect only when the CBR is selected. The
maximum available bandwidth is from the upstream data rate of ADSL status
page.
ENCAPSULATION: Selection follow as Table-1 Configuration
BRIDGE: Enabling bridge mode will place the unit into Transparent bridge mode (like
a Ethernet ADSL modem) to use this mode you should also set your WAN type to
a Bridging option (e.g RFC1482 Bridge using LLC).
IGMP: IGMP relay/proxy specification and environment:
Support IGMP proxy/relay function for ADSL modem, based on the following
requirement and case:
On CO side, there must be at least one IGMP querier (router) present. IGMP
querier will send IGMP query packet. The ADSL modem is responsible to relay
these IGMP query to Ethernet.
24