Epson VIGOR 3300 - Manual (Page 18)

Vigor3300 Series User’s Guide 14
MAC Address Router Default-
Use the default Mac address stored originally in router.
User Definition-
Use a MAC address defined by the user.
Downstream Rate Assign the downstream rate for this WAN interface. The default
value is 102400 kbps (100 Megabit). This setting is very important
for Vigor3300 Series incoming buffer adjustment. If you use a DSL
subscriber service with a 2Mbps downstream, please set the
downstream rate setting with 2Mbps.
Upstream Rate Assign the transmission rate for this WAN interface. The default
value is 102400 kbps (100 Megabit). This setting is very important
for Vigor3300 Series outgoing buffer adjustment. If you use a DSL
subscriber service with a 256Kbps downstream, please set the
downstream rate setting with 256Kbps.
Type Select a connection type for this WAN interface. Currently, there is
only one setting offered for you to choose - Fast Ethernet.
Physical Mode Select connection speed mode for this WAN interface. There are
auto negotiation, full duplex, and half duplex of either 10M or
100M speed options for the WAN Interface.
IP Mode Select an IP mode for this WAN interface. There are four available
modes for Internet access, Static, DHCP, PPPoE, and PPTP. On
this page you may configure the WAN interface to use Static (fixed
IP), DHCP (dynamic IP address), PPPoE or PPTP. Most of the
cable users will use the DHCP mode to get a globally reachable IP
address from the cable host system.