Eicon Networks 1550 - Manual (Page 102)

Web Interface Settings Glossary 102
VHSI Port Menu > Delays Group
DCD (off) -> RTS (on) Delay
Defines the DCD(off) -> RTS(on) delay.
This is the length of time before the remote is allowed to send at the end of reception.
This parameter is intended for non-standard physical interfaces, and is for half-duplex
lines only.
Range: 0-9999 milliseconds. Default: 0 (disabled).
RTS (off->on) Maximum Delay
Defines the RTS (on) -> RTS (off) maximum delay.
This is the length of time the transmitter may be active before turning the line around.
This parameter is for half-duplex lines only.
Range: 0-9999 milliseconds. Default: 0 (disabled).
DCD (on->off) Maximum Delay
Defines the DCD (on) -> DCD (off) maximum delay.
This is the maximum length of time the remote device is allowed to transmit data. If this
limit is exceeded the line is disconnected. This parameter is only used for half-duplex
lines.
Range: 0-9999 milliseconds. Default: 0 (disabled).
TX Idle Timeout
Defines the Tx Idle Timeout.
When the transmitter finishes sending a frame, it starts the Tx Idle Timer. If this timer
expires before another frame is available for sending, the transmitter is turned off. This
parameter is only used in half-duplex mode.
Range: 0-9999 milliseconds. Default: 0 (disabled).