Edirol PC-50 - Manual (Page 16)

16
Getting Connected and Installing Drivers (Windows)
12
Set the PC-50’s power switch to the USB position.
Near the task bar, your computer will indicate “Found New Hardware.”
Please wait.
13
The Found New Hardware Wizard will appear.
Select “Install from a list or specific location (Advanced),” and click
[Next] .
fig.2-7_40
14
The screen will indicate
“Please choose your search
and installation options.”
Select “Don’t search. I will
choose the driver to install,”
and click [Next] .
15
Make sure that the “Model” field indicates “EDIROL PC-50,” and click
[Next] .
Driver installation will begin.
16
The Insert Disk dialog box will appear.
Click [OK] .
17
The Files Needed dialog box will appear.
Input the following into the “Copy files from” field, and click [OK] .
(drive name):\Driver\XP2k.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.
If the Found New
Hardware
Wizard asks
you whether you want to
connect to Windows
Update, choose “No” and
then click [Next].
If the “What action do you want Windows to take?” (Step 4) (p. 14)setting was not set to “Ignore,” a
“Hardware Installation”
dialog box will appear.
A dialog box with a “!” symbol will appear.
1. Click [Continue Anyway].
2. Continue the installation.
A dialog box with a “x” symbol will appear.
1. Click [OK].
2. When the “Found New Hardware Wizard” appears, click [Finish].
3. Return to step 1 (p. 14) and re-install the driver from the beginning of the procedure.
The Insert Disk dialog
may not appear. In that
case, proceed to the next
step.
Specify the drive name of
your CD-ROM drive.
PC-50_e.book 16 ページ ２００５年１１月１０日 木曜日 午前１０時３３分