Eureka 4870 - Manual (Page 6)

Eureka Customer Service HELPLINE 1-800-282-2886 www.eureka.com 4
1) Lower handle to floor and remove HEPA
filter (Fig. 7).
2) Unscrew the lens and remove old bulb.
Replace with bulb rated 12v., 10w.,
Type 904.
3) Push in new bulb, replace lens cover
and replace screw (Fig. 8).
4) Replace HEPA filter and return to
upright position.
Change light bulb (on some models)
Make sure vacuum is turned off and power cord is unplugged.
How to replace brush roll or belt
1) Move brush roll control to ‘bare floor.’
Press firmly until it locks (Fig. 1).
2) Use handle release to lower handle flat
onto floor (Fig. 2).
3) Turn vacuum over. Remove 3 screws
(Fig. 3) and lift off base plate.
4) Remove brush roll and belt.
5) Place new belt around motor shaft and
brush roll. Insert left end of brush roll
first (Fig. 4).
6) Insert right end of brush roll. Make sure
end cap fits into base (Fig. 5). The new
belt may appear to be loose. This is
normal.
7) Rotate brush roll 2 turns to center belt.
8) Insert 4 tabs on base plate into slots on
base (Fig. 6). Rotate base plate down
onto vacuum and replace 3 screws.
!
Fig. 2
Fig. 3 Fig. 4
Fig. 5 Fig. 6
Fig. 7
Fig. 1
Fig. 8
How to Maintain Your Vacuum Cleaner
Make sure vacuum cleaner is turned off and power cord is unplugged
Routine maintenance of your vacuum will help avoid unnecessary service calls. Check the bag, belt and brush roll often.
Check belt. Replace if worn or broken.
Motor can become hot with normal use. Avoid touching the motor shaft when checking brush roll or belt.
!
!
Maintain brush roll
Do not remove end caps. Remove hair and threads from brush roll periodically.