Epson PhotoPC 650 - Manual (Page 49)

Playing Back Pictures 3-13
A
B
3 Press the SELECT button once to open the settings
menu, then press SELECT again to change the month,
highlighted in white.
4 Press the button to increase the number, or the
button to decrease the number, until the month is
correct.
5 Press the SELECT button. The month setting is saved
and the day setting is highlighted.
6 Adjust the day, year, hour, and minute settings as
described above until the date and time are correctly
adjusted and saved.
7 If you need to change the alert beep, Quick
Review mode, or LCD brightness settings, see the next
three sections for instructions.
If you’re finished changing settings, press the BACK
button until you return to playback mode.
NOTE
You need to reset the time and date whenever you replace the
camera’s batteries. In this case, you change the settings through
the Clock Setting menu. See page 1-5 for instructions.
Setting the Alert Beep
The camera’s alert beep lets you know when an image has
been captured. Set the monitor switch to
PLAYBACK , then
follow these steps to turn the beep on or off:
1 Press the SELECT button to display the menus.
2 Press the or button until you see the Settings
menu. The current beep setting is displayed.
3 Press the SELECT button once to open the settings
menu, then press the button to select the beep
setting icon.
4 Press the SELECT button to select On or Off . The
current selection is highlighted. When you turn the
setting on, you hear the camera beep.
5 If you’re finished changing settings, press the BACK
button until you return to playback mode.
Settings
05/15/99
05:15
: On
: On