Emerson Radio CKD1100 - Manual (Page 19)

18
6.) While the Alarm 2 Hour digits are flashing press the or buttons
repeatedly to set the display to the correct wake-up hour.
Example: 9:00 AM
Observe the PM indicator to make sure you have set the wake-up hour correctly.
If the PM indicator is ‘On’ the wake-up time displayed is “PM”". If the PM indicator
is ‘Off’ the wake-up time displayed is “AM”.
7.) When the correct wake-up hour is
flashing press the CLK. ADJ/PROG.
button again.
The Hour digits stop flashing and the minute digits begin to flash.
8.) While the Minute digits are flashing press
the or buttons repeatedly to set
the display to the correct wake-up
minute.
9.) When the desired Alarm 2 wake-up time is showing on the display, press the
CLK. ADJ/PROG. button to store the Alarm 2 wake-up time in the timer memory.
The display stops flashing and returns
to the correct time. The Alarm 2 indicator
disappears.
IMPORTANT: After you press the CLK. ADJ/PROG. button you must make
your wake-up time adjustments within 10 seconds while the wake-up time
display is flashing. After 10 seconds the wake-up time display stops flashing,
the display returns to the correct time, and no wake-up time adjustments can
be made. If this occurs you must begin with Step 1 above and start the wake-
up time adjustment process again.
CKD1100_052107.p65 21/5/2007, 15:56 18