Electrolux C75301K - Manual (Page 11)

Operating Instructions
47
Digital Display
The four display fields correspond to the four cooking zones, and give
the following indications:
– ”-“, when switched on, and when switched off automatically by the
safety function,
– ”0.“, when a cooking zone is selected,
– ”v“, when the Keep Warm setting is selected,
– ”1.“ to “9.“, depending on the selected Cook setting,
– ”A“ ,when Automatic Warm Up is on,
– ”H“, when Residual Heat is on,
– ”F“, if there is a fault.
1
Cooking Zone Safety Cut-out
If one of the cooking zones is not switched off after a certain time or if
the heat setting is not changed, the corresponding cooking zone
switches itself off automatically.
h appears in the ring display for all rings that are switched on, and j
after they have cooled down.
The rings are switched off at:
3 If one or more cooking zones switch off before the times indicated see
section “What to do if …”.
Cancelling the Safety Cut-out
To cancel the activated safety cut-out the appliance must be switched
off and then on again using the ON/OFF
n
sensor field. After this the
cooking zones are again ready for use.
Switching Off for Other Reasons
Liquid that boils over onto the control panel causes all cooking zones to
switch off immediately.
If you place a wet cloth on the control panel it has the same effect. In
both cases the appliance has to be switched on again using the mains
switch
n
after removing the liquid or cloth.
• Heat setting 1 - 2 after 6 hours
• Heat setting 3 - 4 after 5 hours
• Heat setting 5 after 4 hours
• Heat setting 6 - 9 after 1.5 hours