Eureka 78A - Manual (Page 6)

6
Attach Charger Plug to Wall Bracket
CAUTION: Use only charger model 514 for 120 volt;
model AD0412-SV1 for 230 volt.
Your vacuum cleaner has a special bracket designed
to hold the unit, so that it may recharge while mounted
on the wall.
How to Mount your Vacuum Cleaner
Cleaner hangs in bracket with the nozzle end down.
Mount on a wall where there are no dangerous objects
hidden beneath the wall surface like electrical wires,
pipes, etc.
1. Hold bracket against wall to mark location for
screws. Make sure the wall bracket is positioned
vertically, with the charger socket at the top.
2. Use a 1/4 inch drill for drilling holes for the plastic
anchors.
3. Insert the anchors and drive the screws into both
holes, leaving 1/4” of each screw exposed.
4. Place the bracket over the screws and slide the
bracket downward to allow the screws to move
into the slots.
5. Tighten the screws to secure the bracket.
6. Rest the cleaner on the docking ledge, with the
nozzle pointed down, and push in on the top of
the handle until you hear charger socket click into
place.
7. Plug the charger into an electrical outlet.
NOTE: Charge the cleaner for 10-12 hours before initial use. The batteries of a
new cleaner are on a low charge.
Keeping your Vacuum Cleaner Ready for Use
Return your vacuum cleaner to the wall holder after every use. Firmly position into the
mounting bracket ensuring that the vacuum cleaner fits correctly into the charging socket.
It will then be recharged and ready for operation at all times.
The plug charger can be left in the electrical outlet at all times, even when the unit is in
use. It is impossible to overcharge the batteries. The plug charger will become warm,
however, this is not a cause for concern. The unit is charging when the red light on the
top of the vacuum cleaner is illuminated.
Plug Charger
Charger Socket
Docking Ledge