Kichler 337016 - Manual (Page 12)

11
Fig. 21
Fig. 22
Fig. 23
Slide switch
14. OPERATING INSTRUCTIONS
Remove the battery compartment cover on the
back of the CoolTouch™ Transmitter and insert
both batteries provided. Make sure the + sign is
facing up.
Take care during this procedure NOT TO move the
frequency dip switches inside this compartment.
The settings MUST remain the same as the
settings on the receiver for proper communication
with the control system.
It's a good idea to remove these batteries if your
fan is not used for extended periods of time,
(months).
NOTE: Make sure Dip Switch #5 is set to the X
position. This disables the dimming function. You
light fixture utilizes CFL lamps that can NOT be
dimmed.
13. INSTALLING THE BATTERIES
Restore power to ceiling fan and test for
proper operation.
A.
, , and buttons:
These three buttons are used to set the
fan speed as follows:
= High speed
= Medium speed
= Low speed
B. button:
This button turns the fan off.
C. The " " button: turns the light fixture On
or Off. Press and release once for either
On or Off.
DO NOT substitute Incandescent Lamps for
Fluorescent Lamps. You will damage your fan.
This control is designed for use with
"Fluorescent Lamps". It is NOT designed to
control dimming of the light fixture.
This control system is NOT designed to
"Reverse" the rotation of the blades. To set
the fan blades in reverse, the reverse slide
switch is located on the top of the Switch
housing. See Fig. 23.
ON
1 2 3 4
D
X
ON
Code Switch