Kichler 300124 - Manual (Page 9)

8
Richland II
TM
Fig. 11
11. INSTALLING THE SWITCH HOUSING
NOTE: Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box. Turning power
off using the fan switch is not sufficient to
prevent electric shock.
1. While holding the switch housing under your
ceiling fan, push the square wire connectors
together. One from the fan and one from the
switch housing.
NOTE: These connectors are color coded and
will ONLY engage when the colored strips are
matched (aligned).
2. Carefully push all the wires into the switch
housing.
Attach the switch housing to the mounting
plate with the screws provided. Make use
each screw is tight. (Fig. 11)
Switch
housing
Wire connector
Screws
Mounting plate