Kichler 300123 - Manual (Page 9)

8
Richland
TM
Fig. 15
Fig. 16
10. INSTALLING THE MOUNTING PLATE
1. Loosen two screws on the mounting ring
attached to the motor shaft and "remove" and
save the third screw. (Fig. 15)
2. Place the key holes on the mounting plate
over the 2 screws previously loosened from
the mounting ring, turn mounting plate until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 15)
Mounting
plate
Mounting ring
Screws
11. INSTALLING THE SWITCH HOUSING
NOTE: Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box. Turning power
off using the fan switch is not sufficient to
prevent electric shock.
1. While holding the switch housing under your
ceiling fan, push the square wire connectors
together. One from the fan and one from the
switch housing.
NOTE: These connectors are color coded and
will ONLY engage when the colored strips are
matched (aligned).
2. Carefully push all the wires into the switch
housing.
Attach the switch housing to the mounting
plate with the screws provided. Make use
each screw is tight. (Fig. 16) Switch
housing
Wire connector
Screws
Mounting plate