Epson 76C - Manual (Page 41)

Projecting 41
Adjusting the Volume
You can use the buttons on the remote control or projector to increase
or decrease the volume the projector’s built-in speaker. Press the
button to increase the volume, or the button to decrease it. A
volume gauge appears on the screen while the volume is being
adjusted.
Shutting Down the Projector
When you’ve finished using the projector, follow the recommended
procedure to shut it down.
1. If you’re using a computer, shut it down first; otherwise you may
not be able to see your computer’s display to shut it down
properly.
2. To turn off the projector, press the P Power button on the
projector or remote control.
You see this confirmation message:
(If you don’t want to turn it off, press
any other button or wait a few
seconds until it disappears.)
3. Press the P Power button again. The projector beeps twice, the
lamp is turned off, and the power light turns orange.
With Epson’s exclusive Instant Off ™ technology there’s no
cool-down period, so you can pack up and go immediately after
turning off the projector.
note
You can also adjust the
volume using the projector’s
Settings menu. See page 58
for details.
Volume controls
note
When the projector has not
received any input signals for
30 minutes, it automatically
turns off the projector lamp
and enters “sleep mode.” This
conserves electricity, cools the
projector, and extends the life
of the lamp. If you are done
using the projector, unplug
the power cord. If you want
to start projecting again, press
the P
Power button. You
can turn sleep mode on or off
through the Extended menu.
See page 61.
Turn off this product when
not in use to prolong the life
of the projector.