Epson 76C - Manual (Page 61)

Fine-tuning the Projector 61
■ Projection
Front: Projector is in front of the screen.
Front/Ceiling: Projector is in front of the screen, mounted
upside-down from the ceiling.
Rear: Projector is behind the screen.
Rear/Ceiling: Projector is behind the screen, mounted
upside-down from the ceiling.
■ Operation
Direct Power: When this feature is enabled, projection starts
as soon as you plug in the power cord. You don’t have to
press the P
Power button.
Sleep Mode: When Sleep Mode is on, the projector turns
off the lamp if it has not received any input signals for 30
minutes.
High Altitude Mode: When using the projector at an
altitude above 4,921 feet, turn this setting on to ensure that
the internal temperature of the projector is regulated
properly. Turn this setting off for lower elevations.
■ Link 21L
Turn this setting on only if you’re controlling the projector
from a computer with the EMP Link 21L software. This
software can be downloaded from the Epson website at
support.epson.com. (You must turn the projector off and
then on again to use the new setting.)
■ Language
Select the language to be used for the projector menus.
4. When you’re finished, press Esc or Menu .
note
When Direct Power
is turned on, press the
P
Power button to turn
the projector off, wait until
the P power light turns a
steady orange, then unplug
the power cord.