Enterasys Networks 6H302-48 - Manual (Page 27)

3
Installation
This chapter provides the instructions to install the 6H302-48 or 6H303-48 module. A Phillips
screwdriver is required to install options into the module. Follow the order of the sections listed
below to correctly install the module.
• Unpacking the Module ( Section 3.1 )
• Installing Options ( Section 3.2 )
• Installing the Module into the Matrix E7 Chassis ( Section 3.3 )
• Installing the Module into the SmartSwitch 6000 (6C105) Chassis ( Section 3.4 )
• Connecting to the Network ( Section 3.5 )
• Completing the Installation ( Section 3.6 )
ELECTRICAL HAZARD: Only qualified personnel should install the module.
NOTE: Read the Release Notes shipped with the module to check for any exceptions to
the supported features and operation documented in this guide.