Epson STYLUS RX500 - Manual (Page 14)

14 Using the Control Panel
Lights
Adjusting the LCD panel density
You can adjust the density of the LCD panel as follows.
1. Press the P On button to turn on this product.
2. Press the Setup Mode button to enter the Setup Mode.
3. Press the A or the l/r Select button repeatedly until 7.LCD
Contrast
appears on the LCD panel, and then press the x Color
button. The LCD panel is shown below.
4. Adjust the density of the LCD panel. Press the C button to make
the panel lighter, or the D button to make it darker.
5. When the adjustment is finished, press the OK button.
Light Pattern Status
! Error
On An error occurs. (For details, see
“Troubleshooting” on page 84)
Mode
(Copy,
Memory Card,
Scan, Setup)
On Shows the mode this product is in.
A, B, C, D On Indicates the button is valid.
LCD Contrast
A
C
B
D
l - ononon + r