Florabest FHE 550 A1 - Manual (Page 54)

54
MT GB
I
A full tank will last for
approx. 10 minutes of
continuous operation.
Check the oil level in good
time.
• Check the oil fill level and regularly
top up with oil. The oil tank holds
70 ml oil.
• Use Grizzly bio-oil; this product con-
tains additives that reduce wear and
tear and does not damage the pump
system. bio-oil is available from our
Service-Center (see P. 81 for the ad-
dress).
• If you have no Grizzly bio-oil available,
use chain lubrication oil with low adhe-
sive additive content.
1. Unscrew the oil fill cap (23) and
fill up with chain oil.
2. Wipe off any spilled oil and close
the cap again.
Note that the saw can re-oil.
Operation startup
Observe the country-specific and munici-
pal regulations.
Do not work with the high pruning saw
during general ordinary or prescribed
quiet periods.
1. Before starting, check:
- The tension of saw chain 1
- The oil level
- All nuts and screws are sitting firmly
- Only remove blade cover 24 at the
last minute
- Set the working length of the telescop-
ic arm before switching on the equip-
ment
- Check that shoulder strap 12 is in a
comfortable position that eases your
hold on the high pruning saw
- Ensure that you are wearing protec-
tive clothing
- Check that you are standing safely
- Check your working surroundings
2. Switching on
- Connect the equipment to a power
supply with the supply voltage speci-
fied on the rating plate.
- Hold the equipment firmly in a relaxed
and safe manner. Operate starting
lock 11 and switch on the pruning saw
at on/off switch 10.
- The equipment will switch off again
when you release on/off switch 10.
- For safety reasons, a lockable contin-
uous operation setting is not possible.
Adjusting the Telescopic
Handle
The telescopic handle can be infinitely
adjusted using quick release 15. Push the
lever forward as shown in the illustration
then push and pull to adjust the handle
length.
Pull back the lever and so fix the desired
working length of the telescopic handle.
Handle Adjustment
• Loosen pivotal centre 8 and and fixing
the adjustable handle 9 on position.
• Replace the pivotal centre 8 to fixation.
H
10 min
G