Initial operation, Gb mt – Florabest FGPS 1100 B2 User Manual

Page 18

Advertising
background image

18

GB MT

• Attach the prefilter with reflow stopper

(15) to the connector prefilter (16) at the

pressure hose (13). Both piecese mar-

ked with a

B

.

• Remove the protective cap (

B

1) from

the garden pump water inlet (2).

• Attach the Adapter (11) to the water inlet

(2) . Both pieces marked with an

A

.

• Attach the connector water inlet (14) with

the seal ring (12) to the adaptor (11).

Both pieces marked with an

A

. Fit the

water inlet free from air.

• Remove the protective cap (

B

3) from

the garden pump water outlet (4).

• Fit a pressure hose to the water inlet (2)

Fit the water inlet free from air.

Air in the suction hose will stop the

garden pump from working prop-

erly.

Filling the pump

Fill up the garden pump every time before

you start using it. This will ensure an im-

mediate start. Running dry will destroy the

pump.

• Open the filling screw (

A

9) on the

garden pump.

• Fill with water to the fill point such that

water starts to run out of the filling

screw (

A

9) hole. Retighten the filling

screw (

A

9).

Operational start-up

• Check that the electrical connec-

tion is 230V ~50Hz

Initial Operation

Assembly

C

• Fix the carrying handle (

C

7) to the

garden pump using the fixing screws

(

C

8).

Mains Connection

The pump you have purchases is already

fitted with an earthed plug. The pump is in-

tended for connection to an earthed socket

at 230 V ~ 50 Hz.

Setting up

• Place the unit on a firm, horizontal,

non-flooding surface.

• To permanently install the garden

pump, screw it to the ground. Screw-

ing it to a fixing panel will prevent the

appliance from moving.

• Always put up the garden pump at a

point higher than the water surface

you wish to pump water from.

Where this is impossible, install a low

pressure-resistant shut-off implement

between the appliance and the suction

hose (Available from specialist retail-

ers).

• Connect the power cable (6) to the

power supply.

Connecting the hoses

On the suction side, attach a hose

with reflow stopper and install a

prefilter (Available from specialist

retailers). On the suction side, do

not use any quick-action connection

systems.

D

E

Advertising