Operation, Changing bulbs – Melinera Z30233A-BS/Z30233B-BS User Manual
Page 8
10 GB/IE/CY
Melinera
®
Operation
Q
Changing bulbs
DANGER TO LIFE BY ELECTRIC SHOCK!
Always unplug the mains plug
4
from the socket before installa-
tion, dismantling, maintenance or cleaning.
CAUTION! RISK OF BURNS! Allow the string of lights
1
to cool down completely before changing the bulbs
6
.
j
Turn the lamp shade
2
anticlockwise and pull it off the can-
dle body
3
. Then pull the candle body
3
from the LED light
set
1
.
m CAUTION! RISK OF INJURY! Be very careful when you
are doing this. The bulbs
6
may otherwise be damaged.
j
Remove the faulty bulb
6
from the fitting
8
by bulb remover
7
(see Fig. B).
j
Plug a new bulb into the fitting
8
.
CAUTION! Make sure that the type, operating voltage
and wattage are correct. Never use other than the stated
bulbs
6
.
CAUTION! The bulbs
6
have a plug-in system. Never
screw the bulbs
6
in. This can cause damage.
Note: the bulb
6
will only light up if it is fitted the right way
round. The marks on the bulb
6
and the fitting
8
have to be
in line with one another (see Fig. B). Remove the bulb
6
if it
does not light up and replace it in the opposite direction.
Note: make sure that the wires are pointing upwards and
that there is no foreign matter in the fitting
8
.
j
Place the candle body
3
back on to the LED light set
1
.
Then place the lamp shade
2
on the candle body
3
and
turn it clockwise to tighten it.
66410_BS_mel_LED-Lichterkette_Content_LB6.indd 10
05.05.11 12:41