Melinera 105208-14-0х - Manual (Page 9)

9 GB/IE
depends on the amount of sunlight, the angle of light on the solar
panel and the temperature (the battery capacity is temperature-
dependent). A vertical angle of light at temperatures above the free-
zing point is ideal. The rechargeable battery will only achieve its
maximum capacity after several charging and discharging cycles.
Start-up
Mounting the light
Install the light in accordance with figure A.
Rotate the solar housing
2 anticlockwise out of the lamp
shade 3 (see fig. A).
To switch on, set the ON / OFF switch 7 to the „ON“ position,
so the device turns on during darkness (see fig. B).
Insert the solar housing into the lamp shade and tighten by turning
clockwise (see fig. A)
Your lamp is now ready for use. You must now decide whether you
want to use your solar light as a hanging lamp or a floor lamp.
Usage as a Floor Lamp:
Insert the rod 4 into the lamp shade 3 and insert the ground
stake 5 into the rod (see fig. A). At delivery, take note of whether
the ground stake is inserted into the rod with the spike. Remove,
if necessary, the hanger
1 from the lamp shade, by slightly
bending the handle outwards.
Insert the assembled solar light far enough into the ground
(lawn, flower bed) for it to be stable.
105208_LED-Solarleuchte-2in1_content_IE_BE.indd 9 04.11.14 09:13