How to replace worn belt or light bulb – Eureka 6998 Series User Manual

Page 7

Advertising
background image

Continued

5. Insert hose coupling into top of canister.

6. Push hose plug into receptacle at handle.

NOTE: On models with Remote Speed Control, hose

plug must be inserted for canister to turn on.

7. Pull cord out and push plug into outlet. To rewind,

step on Cordaway cord reel button, hold and guide
plug while it rewinds.

8. Step on motorized nozzle; pull back to comfortable

work position.

9. Push On/Off canister switch.

(A thermostat automatically shuts off the motor if it
overheats, see Automatic Motor Shut-Off.)

10. Bare floor or carpet cleaning selection on remote

control, only.

NOTE: Optional remote controls on the hose

handle operate only if the canister
switch is on.

14

7

6

9

5

s

7

7

How to Replace Worn Belt or Light Bulb

(On Some Models)

NOTE: Disconnect power cord and wands from electrical hose before replacing belt or bulb. Belt pulleys can become

hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt.

3. Lift out brush roll and discard used belt. Place new

belt around brush roll pulley.

2. Remove two screws located in front of the light bulb

and lift up to remove the brush roll cover.

1. Remove two screws from bottom side. Turn over to

grasp hood near handle socket and lift forward.

Replace headlight bulb, if necessary. Use GENUINE
EUREKA 25 watt replacement bulb 40009A. Continue
to step 2 to change belt. Skip to step 7 and 8 to replace
hood on motorized nozzle.

4. Return

brush roll
into
base.

5. Rotate belt onto motor pulley.

6. Replace brush roll cover.

Look for the

symbol.

Use GENUINE EUREKA replacement belt, 58065.

7. Tilt cover over ridge and push down.

8. Secure with screws on underside (refer to 1).

Ridge

{

Brush
Roll
Pulley

Motor Pulley

{

Advertising