Epson EB X6 - Manual (Page 52)

Problem Solving 52
f t Power indicator lights red
: Lit : Flashing: : Off
Status Cause Remedy or Status
Internal Error Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest
address provided in the Support and Service Guide. s
Epson Projector Contact List
Fan Error
Sensor Error Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest
address provided in the Support and Service Guide. s
Epson Projector Contact List
Auto Iris error Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest
address provided in the Support and Service Guide. s
Epson Projector Contact List
High Temp Error
(overheating) The lamp turns off automatically and projection stops. Wait for about five minutes. After about five minutes the projector
switches to standby condition, so check the following two points.
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it. s
p.65 , 71
If the error continues after checking the points above, stop using the projector, disconnect the power cable from the
electrical outlet, and contact your local dealer or the nearest address provided in the Support and Service Guide. s
Epson
Projector Contact List
When using at an altitude of 1500 m or more, set "High Altitude Mode" to "On". s p.45
Problem
Red
Red
Red
Red
Red
Red
Red
Red
Red
Red