Vesa mount on your touchmonitor – Elo TouchSystems 192XL-XXWA-1 Series User Manual
Page 20
Advertising
VESA Mount on Your Touchmonitor
Figure 2.4 Stand and Display Separation
NOTE: The above drawing displays the VESA mounting interface after the removal of the
mounting cover and base.
NOTE: You will need a 3mm Hex Wrench for the following steps.
• Remove the four screws in order to separate the stand from the monitor
(see Figure 2.4).
• Rotate the monitor 180° (ensuring the monitor will not be upside down
when mounted in the position shown).
• Reinstall the four screws.
• Route the cables through the cutout (if applicable) and mount the
monitor to the wall using the template in Figure 2.
Elo Entuitive Touchmonitor User Guide
20
Advertising