Fig.3, Maintenance – Sealey SA686 User Manual
Page 3
6. MAINTENANCE
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
DO NOT use any additional force upon the wrench in order to remove a nut.
DO NOT allow wrench to free run for an extended period of time as this will shorten
its life.
WARNING! Disconnect wrench from air supply before changing accessories, servicing or
performing maintenance. Replace or repair damaged parts. Use genuine parts only.
Unauthorised parts may be dangerous and will invalidate the warranty.
6.1. If the air system does not have an oiler, lubricate the air wrench daily with a few drops of
Sealey air tool oil dripped into the air inlet.
6.2. Clean the wrench after use. DO NOT use worn, or damaged sockets.
6.3. Loss of power or erratic action may be due to the following:
6.3.1. Excessive drain on the air line. Moisture or
restriction in the air pipe. Incorrect size or type of
hose connectors. To remedy, check the air supply
and follow instructions in Section 3.
6.3.2. Grit or gum deposits in the wrench may also
reduce performance. Remove the strainer, clean
it and flush the wrench out with gum solvent oil or
an equal mixture of SAE No: 10 oil and paraffin.
Allow to dry and then lubricate before use.
6.4. For a full service, contact your local Sealey
service agent.
6.5. When not in use, disconnect from air supply,
clean wrench and store in a safe, dry, childproof
location.
fig.3
© Jack Sealey Limited
Original Language Version
SA686 Issue: 4(SP) - 16/12/13
Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and
disposed of in a manner which is compatible with the environment.