Sealey S01044 - Manual (Page 3)

4. OPERATING INSTRUCTIONS
 WARNING! Ensure you read, understand and apply safety instructions before use.
4.1. Assembly.
4.1.1. Apply appropriate sanding disc to the backing pad. Use only pads with speed ratings equal to or higher
than the speed rating of the sander. DO NOT use cloth backed sanding pads.
4.1.2. Connect air supply to sander and press the control valve lever and check that the sander is working
correctly.
4.1.3. the air flow may be regulated by turning the throttle valve on the side of the handle.
4.2. Operation.
the sander is designed to provide a combined rotary and random orbit action.
Always use sanding disc with grit appropriate for the job. Work progressively from coarse grades to finer
grades. DO NOT go from coarse to fine in one step as it may be difficult to remove swirl marks left by the
coarser grit. DO NOT apply excessive pressure, let the sander do the work for you. Start the sander and
bring the sanding disc to the work surface evenly and slowly. Move the sander back and forth in
overlapping areas. Remove the sanding disc from the work surface before stopping the sander. Regularly
check the sanding pad for wear, always changed a cracked or damaged pad.
DO NOT allow sander to run in “idle rotation” for an extended period of time as this will shorten life of the
bearings.
© Jack Sealey Limited
fig.1 fig.2
S01044 Issue: 2(SP)- 14/08/13 Original Language Version