Cleaning agent change – Sealey SM23/2 User Manual
Page 3
6. CLEANING AGENT CHANGE
R
WARNING! It is operator’s responsibility to ensure that there is no uncontrolled discharge of any fluids used with this unit and
that appropriate arrangements have been made for correct disposal of waste in accordance with government/local authority
regulations.
R
WARNING! Disconnect the air supply from the unit before changing accessories, servicing or performing any maintenance.
R
WARNING! Wear approved safety gloves, goggles, mask and suitable clothing.
6.1.
Replacement of cleaning water.
6.2.
The number of guns that can be cleaned will depend upon the amount of residual paint which is left in the spray equipment. We
recommend however that the cleaning water is changed on a regular basis to provide optimum cleaning performance and that
paint sludge is removed weekly, as detailed below.
Sludge removal:
6.3.
Drain 2 litres of water/sludge from the drain valve (66). Close the valve and add clean water to the tank to bring the level up to at
least 25mm above strainer.
Water change:
6.4.
Drain the dirty water completely from drain valve (66). Clean inside the tank (2) and strainer (59) before refilling with clean water.
Dispose of contaminated water in accordance with local authority regulations.
6.5.
MAINTENANCE:
Weekly, remove pump upper cap (45) and add grease.
6.6.
Regularly check that opening the washer lid automatically stops the spray.
6.7.
Regularly check and top up the oil in the air supply oiler.
6.8.
Keep the outside of the unit clean.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
Sole UK Distributor, Sealey Group.
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk.
IP32 7AR
www.sealey.co.uk
01284 757500
01284 703534
Web
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
SM23/2.V3 | Issue 3(S) 01/04/15
Original Language Version
© Jack Sealey Limited