Sealey AB932 User Manual
Ab932.v4, Safety instructions 2. introduction & contents, Assembly
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR
WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according
to these instructions and properly maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
2. INTRODUCTION & CONTENTS
2.1
INTRODUCTION
Metal body with suction bottle or thimble feed options. Paint delivery controlled on single thumb screw.
Supplied with 0.35mm nozzle. Includes two 22cc glass pots, one 5cc metal cup, 1.6mtr small bore hose,
1/4” reduction nipple, wrench and hanging bracket. Supplied in storage-case.
2.2
CONTENTS
Air brush with 0.35mm nozzle and protective cap
Two 22cc glass jars with lids.
1.6mtr of small bore hose.
Paint cup.
1/4” reduction nipple to connect to other compressors. Wrench and hanging bracket.
Fig.1
3. ASSEMBLY
3.1
Fit the jar cover with nozzle, or the paint cup into the body
of the air brush as shown in figs.1 and 2. Twist firmly into
place.
3.2
Screw one end of the air hose onto the air hose connection
underneath the air brush trigger and the other end onto the
air supply.
3.3
To use a propellant can (Sealey Part No: AB/P) a regulator
valve/cap (Sealey Part No: AB930/11) should be purchased,
see fig.1.
3.4
To use a compressor such as the Sealey Model No: AB900 use
the adaptor supplied with the compressor to connect the air
hose,
as shown in fig.3.
3.5
To use the air brush with other types of compressors use the
1/4” reduction nipple supplied.
NOTE: The maximum air
supply to the air brush should never exceed 50psi.
Normal operating pressure is approx 30psi.
WARNING! Ensure that Health and Safety, local authority and general workshop practice regulations are
adhered to when using tools.
WARNING! Air brushes produce a fine mist of paint and solvents which may be harmful by inhalation.
Always wear suitable protective breathing equipment which can be obtained from your local Sealey
Dealer. For a better understanding of the risks involved with any particular paint or solvent read the
warnings on the containers and follow the advice given.
Also take measures to protect the eyes and skin from contact with paint and solvents. A full range of
personal safety equipment is available from your Sealey Dealer.
DO NOT operate the air brush near other people unless they are wearing the same protective equipment.
DO NOT eat or drink when using the air brush.
DO NOT allow smoking or open flame in the work area.
Ensure that the air brush and accessories are in a clean, sound condition and good working order. Take
action for immediate repair or replacement of damaged parts. Use recommended parts only.
The use of unauthorised parts may be dangerous and will invalidate the warranty.
Ensure the air brush supply hose is not tangled, twisted or pinched.
DO NOT use air brush or accessories if damaged.
DO NOT operate air brush while under the influence of drugs, alcohol or intoxicating medication, or if fatigued.
DO NOT direct spray against yourself, other persons or animals or electrical equipment.
DO NOT use the air brush for a task it is not designed to perform.
Always ensure adequate ventilation in the work area.
Always disconnect from the air supply before dismantling the air brush for cleaning and maintenance.
DO NOT leave the air brush connected to the air supply when unattended.
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or telephone 01284 757500.
Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste.
All tools, accessories and packaging should be sorted, taken to a recycle
centre and disposed of in a manner which is compatible with the environment.
Original Language Version
Original Language Version
AB932.V4 Issue: 1 - 11/02/14
AB932.V4 Issue: 1 - 11/02/14
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
W e b
© Jack Sealey Limited
© Jack Sealey Limited
INSTRUCTIONS FOR:
AIR BRUSH KIT PROFESSIONAL
WITHOUT PROPELLANT
MODEL NO:
AB932.V4