Sealey TC414 User Manual
Page 2
4.1. Changing the tile cutter.
4.1.1. Undo nut fig.8.A and remove pin and cutting wheel.
4.1.2. Refit pin and new cutting wheel.
4.1.3. Refit washer and tighten nut.
4.2. Changing the hole cutter (TC4163 only).
4.2.1. Prevent the main shaft, fig.5.A. from rotating and, using a 10mm open ended spanner, undo the hole cutting fixture fig.5.B.
4.2.2. Fit new fixture and tighten.
3.2 Hole Cutting (TC4163 only).
3.2.1. Unscrew and remove the handle fig.4.A.
3.2.2. To ensure the hole cutter is securely fitted to the main shaft, prevent the main shaft, fig.5.A from rotating, then, using a 10mm open ended
spanner, tighten the hole cutter, fig.5.B.
3.2.3. Loosen nuts fig.5.C & D. and adjust the height of the cutter such that the side flats of the pilot drill enter the tile prior to the cutter.
3.2.4. Position the cutter accordingly for the size of hole required and tighten the upper nut, fig.5.C.
3.2.5. Screw the operating arm, fig.6.A, into the main shaft, fig.6.B.
3.2.6. Undo the nut, fig.6.C and remove the lower securing plate from the hole cutting attachment.
3.2.7. Position the hole cutter on the guide rails fig.7, attach the lower securing plate and position centrally over the hole in the base.
Tighten the securing nut.
3.2.8. Raise the main shaft by pushing downwards on the lever fig.6.D and place a tile on the cushioned base. Align the pilot drill with the
centre of the required hole. Lower the main shaft, hold the tile firmly in place and rotate the operating arm.
3.2.9. Once the required hole has been cut, raise the main shaft and remove the tile.
4.
MAINTENANCE
5.
PARTS LIST
Item No Part No Description
1
TC314CW
Cutting wheel for TC314
2
TC414CW
Cutting wheel for TC414
3
TC4163CW
Cutting wheel for TC4163
4
TC4163PDC
Hole cutter for TC4163
01284 757500
E-mail:
01284 703534
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice. IMPORTANT: No liability is accepted
for incorrect use of this equipment. WARRANTY: Guarantee is 12 months from purchase date. proof of which will be required for any claim. INFORMATION: For a copy of our latest catalogue
and promotions, call us on 01284 757525 and leave your full name and address including your postcode.
Sole UK Distributor, Sealey Group, Bury St. Edmunds, Suffolk.
TC314, TC414, TC4163 - 1 - 060302
Fig 5
Fig 8
A
D
A
B
C
Fig 6
A
B
C
Fig 7
D