Sealey SD400K User Manual
Sealey Tools
INSTRUCTIONS FOR:
SOLDERING KIT
MODEL No:
SD400K
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE
PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL
INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
2. INTRODUCTION
3. CONTENTS
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment,
make sure you know where the nearest fire extinguisher is.
WARNING! Always wear approved eye / face protection when operating the torch.
WARNING! DO NOT use the torch if you notice that it is damaged or if there could be a gas leak from it.
WARNING! Butane gas is extremely flammable, handle with care.
WARNING! Always point the torch away from the eyes and body when igniting and during operation.
WARNING! DO NOT put the torch down when it is lit, DO NOT leave it unattended.
WARNING! The flame is not easily visible in bright daylight.
WARNING! Ensure the flame is completely extinguished after use. DO NOT use water to cool the torch down.
WARNING! Only use in a well ventilated area.
DO NOT use the torch in an area where paint fumes, solvents or other flammable solids, liquids or gases pose a potential hazard. Keep
flammable material away from the torch when operating.
DO NOT operate the torch when you are tired or under the influence of alcohol, drugs or intoxicating medication.
DO NOT hold any workpiece by hand.
DO NOT touch the workpiece close to the heated area as it will be very hot. Allow to cool.
DO NOT operate the torch if it is damaged as this may cause failure and/or possible personal injury.
DO NOT touch the top of the torch during or immediately after use, as it will be very hot. Allow to cool.
DO NOT allow children to operate the torch.
After use, allow the torch to cool before storing it.
When not in use, store away from direct sunlight in a safe, dry, childproof location.
DO NOT store at over 40°C, such as in a car in hot weather.
Original Language Version
© Jack Sealey Limited
SD400K Issue: 1 - 02/09/14
Soldering torch
Hot Air Nozzle
Deflector Nozzle
3 x Tips
Hot Knife
115mm Side Cutters
Electrical Shears
3mm Desoldering Braid
Wire Stripper/Cutter/Crimper with Wire Guide
Heat Shrink Pack: 1.5, 2.5, 3, 5, 6mm
Comprehensive soldering/heating kit ideal for any handyman, enthusiast or electrician. This kit includes a variety of necessary tools and
accessories for a range of applications. Features a high powered soldering, heating and shrinking torch with piezoelectric ignition. Also included is a
pack of varied size heat shrinks and high quality electrical shears. Supplied in a heavy-duty BMC case.