Sealey BSL104 User Manual
Cvj boot tool - mechanical, Bsl104, Instructions for
Original Language Version
Model No:. ..............................................................BSL104
Maximum joint diameter: .......................................... 110mm
Drive: .........................................................................8.5mm
Innovative tool saves time, money and frustration. Installs CVJ boots without removing drive shaft from the vehicle or the CV joint from the
drive shaft. No effort and no mess! Save on labour time by up to 70% and prevent damage to CV joint. Suitable for cars and light commercial
vans. Composite body with 8.5mm hex drive. Used in conjunction with drill with standard chuck. Fingers are mechanically open/closed by the
rotation of the drive.
1.1
GENERAL SAFETY
Carefully read these operating and safety instructions before using the boot tool. Keep them for future reference.
This tool should only be used by properly trained operators.
Keep the work area clean, uncluttered and ensure there is adequate lighting.
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
Remove ill fitting clothing. Remove ties, watches, rings, and other loose jewellery, and contain and or tie back long hair.
Keep children and unauthorised persons away from the working area.
Keep the boot tool away from fire, heat and chemicals.
DO NOT use the boot tool for any purpose other than that for which it is designed.
DO NOT operate the boot tool when you are tired, under the influence of alcohol, drugs or intoxicating medication.
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment.
1.2.
MECHANICAL SAFETY
Maintain the boot tool in good condition (use an authorised service agent).
If the tool falls or is knocked, stop operation and check for any damage i.e. cracked components.
Do not erase or damage any of the markings, symbols or text printed onto or moulded onto the surfaces of the boot tool.
In case of mechanical fault and/or breakage and/or cracks, immediately stop operation of the tool. Contact an authorised distributor.
Replace or repair damaged parts. Use genuine parts only. Non-authorised parts may be dangerous and will invalidate the warranty.
DO NOT operate the boot tool if any parts are damaged or missing as this may cause failure and/or personal injury.
1.3.
OPERATIONAL SAFETY
WARNING! The boot tool MUST NOT be used with impact guns or drills on their hammer setting.
Before using the boot tool, make sure that all the boot tool parts are correctly assembled and firmly in place.
DO NOT operate it if the
arm retaining pins are not all in place.
Working with the boot tool requires protective equipment including safety shoes, work gloves and safety goggles.
DO NOT bring the
tool close to the face while operating.
When operating the boot tool, to open a CV rubber boot, turn the tool away from your face and body.
Keep hands clear of the moving parts when operating the boot tool. Never insert fingers into the tool.
DO NOT point the boot tool at any person and/or towards any part of the operator's body.
BSL104 ISSUE No:1 21/04/14
INSTRUCTIONS FOR:
CVJ BOOT TOOL - MECHANICAL
MODEL NO:
BSL104
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE
PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
1. SAFETY
2. INTRODUCTION
3. SPECIFICATION
© Jack Sealey Limited