Sealey SWT1120 - Manual

INSTRUCTIONS FOR:
WELDING TABLE 1120 X 610MM
MODEL NO:
SWT1120
3 Select a work area suitable for the table and keep the area clean, tidy and free from unrelated materials. Ensure there is adequate
lighting.
3
Stand the table on a stable floor strong enough to take the weight of the table.
3 Maintain the table in good condition.
3 Replace or repair damaged parts. Use recommended parts only, unauthorised parts may be dangerous and will invalidate the warranty.
3 Remove ill fitting clothing, remove ties, watches, rings and other loose jewellery and contain long hair.
3 Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
3 Keep children and unauthorised persons away from the work area.
Heavy-duty galvanised welding table with 30mm MIG torch mounting point. Portable and foldable for ease of transportation and storage when
not in use. Sturdy locking pin system and adjustable foot for eliminating wobble when in use.
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . SWT1120
Size Folded (WxDxH): . . . . . . . . . 1120 x 610 x 915mm
4 .1 . Lay table upside down on floor. Remove leg securing pin, (see fig.1).
4 .2 . Pull inner leg (the one with the height adjusting bolt), up and over to erect legs.
4 .3 . Once the legs reach their stop, reinsert the pin and 'R' clip in its end, to secure the legs in position, (see fig.2).
4 .4 . Get the help of an assistant to turn the table the right way up.
4 .5 . Use the height adjusting bolt to stabilise the table before using.
1 . SAFETY
2 . INTRODUCTION
3 . SPECIFICATION
4 . OPERATION
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY . NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS . USE THE
PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED . FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY . KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE .
fig.1
fig.2
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
W e b
email
Original Language Version
STW1120 Issue: 1 - 14/08/14 © Jack Sealey Limited
Environmental Protection .
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.