Sealey PC100 - Manual (Page 2)

3. INTRODUCTION & SPECIFICATION
4. CONTENTS & ASSEMBLY
Item . . . . . . . . Description
1 . . . . . . . . . . . . . . .Handle.
2 . . . . . . . . . . Power Head.
3 . . . . . . . . . . . Blower Port.
4 . . . . . . . . . . . Filter Cage.
5 . . . . . Accessory Storage.
6 . . . Cable Stowage Hook.
7 . . . . . .Safety Float Valve.
8 . . Flexible Vacuum Hose.
Item . . . . . . . . Description
9 . . . Reusable Cloth Filter.
10 . . . . . . . . . . . . . . .Brush.
11. . . . . . . . . . Crevice Tool.
12 . . . . . . . . . . Foam Filter.
13 . . . . . . . . On/Off Switch.
14 . . . . . . . . . Vacuum Port.
15 . . . . . . . . Locking Knob.
16 . . . . . . . .10ltr Container.
4.1. Ensure the mains plug is disconnected. Do not connect to
the mains power until the unit is correctly assembled and
prepared for the cleaning task in hand.
4.2. Rotate the two locking knobs on either side of the power
head clockwise to release the head.
4.3. Lift the power head off the container and turn it upside
down ready to fit a filter.
4.4. Remove the contents from inside the container and check
the items against the contents list above. If anything is
missing or damaged please contact your supplier
immediately.
4.5a For dry vacuuming fit the reusable cloth filter over the filter
cage.
4.5b. For wet vacuum remove the cloth filter and put the foam
filter over the filter cage.
NOTE: Do not operate the cleaner without any filter fitted as
this will damage the motor and invalidate your
warranty.
4.6. Replace the power head onto the container ensuring that it
is correctly seated.
4.7. Secure the head by turning the locking knobs
anticlockwise.
4.8. Insert the flexible hose into the front inlet port below the
on/off switch.
4.9. Connect the brush or crevice tool to the other end of the
hose.
4.10 When vacuuming is complete the brush and crevice tools
can be stored using the grooved stowage positions on
either side of the power head.
3.1. Introduction.
High powered, lightweight, wet and dry unit with blower facility.
Constructed from high impact composite with tool and hose
stowage points on head. Ideal for vehicle cleaning and general
workshop use. Supplied with crevice and floor tools, cloth and
foam filters, 2mtr cable and 3-pin plug.
fig. 1
Original Language Version PC100 Issue: 2 - 22/10/09